HM-10 BLE 4.0 ModuleThe HM 10 Bluetooth module combines the Texas Instruments CC2541 Chipset with the necessary components to get started with BLE development right away. TTL level and 5 V tolerant, the module has an onboard voltage regulator. The Bluetooth SoC can be accessed through a UART interface and can be configured using AT Commands. It complies with the Bluetooth 4. 0 standard and can be used to connect an Arduino or microcontroller to an Android or iOS device.

Because the sensor circuitry is enclosed

nuts & bolts

It's a SD16 2 Pin Male-Female Waterproof Power Connector Pair

2 AC/L&N Supplied AC Voltage (88 ~ 264VAC) 3 FG GND 4 V2(+V) DC OUTPUT +12V 5 COM Negative for DC Outputs 6 V1(+5V) DC OUTPUT +5V

please refer to the testing pattern

IB1 external MCU 10 port

Resistance Value 2

These Foil Tapes can be applied for both high/low temperatures

4 BO motors and a pack of Screws and Hexnut

These are Carbon Film Resistor with a value of 820 ohm 1/2W and tolerance of ±5%

These are Carbon Film Resistor with a value of 470 ohm 1/2W and tolerance of ±5%

These are Carbon Film Resistor with a value of 100 ohm 1/4W and tolerance of ±5%