Plastics pipes and fittings. Equipment for fusion jointing polyethylene systems - Butt fusion1 Scope This document specifies the general characteristics of, and performance requirements for, equipment for butt fusion jointing of polyethylene (PE) piping systems using electrically powered heater plates. It is applicable to mechanical and pressure activated equipment for butt fusion jointing of PE pipes and fittings either intended to be used for the supply of gaseous fuels, conforming to ISO 44372[1] and ISO 44373[2], or intended for the

5 Reference images

BS EN 12173 gives information on its use in water treatment

Rubber and plastics hoses can be produced in a wide variety of tube diameters and wall thicknesses

Companies dealing with the document structuring

BS EN 16322 discusses the Conservation of cultural heritage

because of their direct product contact

This is because the distance for spectators varies depending on the category of firework (1 m for category 1 fireworks

Manufacturers of self-supporting aerial telecommunication cables

“The Community said” - comments made during Community Brainstorm Day and via a discussion portal

to lawn edge trimmers or to brush cutters equipped with metalic blades consisting of more than one part

This European Standard is not a design manual

mineral oil resistant