Jensen 030 Cylinder Assembly, Complete-Model # 25.Cylinder Assembly, Complete Model # 25. Same as Model 75 BOTH instructions on how to take the old one off AND then, put the new one on: 1. Take the hollow steam screw out on the top front of boiler which holds the steam pipe on. 2. The 2 steam chest screws that connect the steampipe to the flat part of the cylinder take them out. 3. Take the crank pin screw off (which holds the connecting rod to the crank shaft). 4. Then loosen 6 32 set screw on the 2

equally tighten these screws in order to gap the terminals so they do not touch the walls of the firebox

Steam Line - Model # 25

Complete-Model # 65 (with steam line)

Jensen Steam Engine Boiler - Model # 25

The Model # 20-G is our "Original" Brass & Cast Iron Engine and Power Plant from 1932

Spring loaded safety valve

Burner slide

Chiseling the rivets off from the inside

Complete accessory set in a bag for Wilesco D 3

Jensen Steam Engine Air Compressor Adapter Unit

Fun & easy two hour project for parents & child

Steering rod (RC-control) for Wilesco D 320